How To Get Measurements for the Waterproof Cast Cover
1) MEASURE LENGTH
ARM:
Measure from the tip of the middle finger to the top end of the cast or prosthetic. If the cast goes above the elbow, follow the bend of the arm.
LEG:
Measure from the back of the heel (from the floor) to the top end of the cast or prosthetic.
Choose a Dry Pro ™ waterproof cast cover that is at least 2 inches LONGER than your measurement.
Don't worry if the Dry Pro ™ Pump waterproof cast cover is too long. The excess material of the cast sock will flatten down when the air is pumped out.
2) MEASURE OPENING
ARM:
Measure the circumference of the arm just above the cast or bandage (If the end of the cast is very close to the elbow, measure mid bicep.)
LEG:
Measure the circumference of the leg just above the cast or bandage (If the end of the cast is very close to the knee, measure mid thigh.)
Choose a Dry Pro ™ waterproof cast cover that is at least 1 inch SMALLER than your measurement.
To create a good vacuum seal the opening of the cast sock needs to be smaller than your limb.
